Registered User
Currently Offline
|
Posts: 22
Join Date: May 2008
|
We have a customer that has asked us to quote a hot stamp to the front side of a plastic chair back. We have a standard hot stamper but it will not be able to do the back because of the contoured surface. I was looking on line and it appears that it could be done with the correct equipment. This is a special one time order of only 100 parts so the opportunity is not large. Any of you out there have the capability to do this and want to take a look at it? If so contact me. Thank you.
Doug Baril
715-276-4217
doug.baril@nicoletplastics.com
|
