Page 1 of 1

Injection Molding Classes

Posted: Thu Apr 04, 2019 2:27 pm
by NortheastUSAMolding
Hi I am looking to have our existing employees learn to become a molding technician. He has no prior molding experience. Ideally I would like him to take injection molding classes to become a knowledgeable technician. I have taken a look at Penn State and Umass classes. Does anybody have experience with these programs or any others not mentioned. Your help would be much appreciated!


Thank you.

Re: Injection Molding Classes

Posted: Mon Apr 08, 2019 4:52 pm
by ch3solutions
I do not have any experience with the 2 you mentioned. we use AIM, RJG, Routsis and Paulson training. Some of these can be taken online. He would need some basic molding education to start with and any of the ones listed can help you. Websites below.

https://aim.institute/
https://www.rjginc.com/
https://www.traininteractive.com/training/online/
https://www.paulsontraining.com/

Re: Injection Molding Classes

Posted: Mon Apr 08, 2019 4:58 pm
by NortheastUSAMolding
Thank you for your help, as it is much appreciated