Page 1 of 1

Injection Molder needed - short runs

Posted: Mon May 11, 2020 4:43 pm
by ArrowheadThermoforming
All,
We are a heavy gauge thermoformer. A client of ours recently inquired about us making a fuse box for them. The design lends itself to injection molding. If you are a company that specializes in small run injection molded parts, please let me know as I have a job for you to look at. We are always looking for other plastic companies to partner with for reciprocal lead sharing for situations such as this. This job would be 1000+ parts a year.



My contact info is below if interested. Thanks everyone and God bless.

Mark Kishel
Arrowhead Plastic Engineering
765-396-4443
mkishel@arrowheadinc.com

Re: Injection Molder needed - short runs

Posted: Thu May 14, 2020 8:54 am
by wepcoplastics
Hi Mark,
Wepco Plastics is a fellow MAPP member and an injection m older out of Connecticut. We manufacture our own tooling in house as well. I would be happy to connect with you on this project and see if we can be of assistance. My email is amanda@wepcoplastics.com.

Amanda Wiriya